Ms Wang: Ms Mao, can you tell me about this product?

Ms Mao:This is the rear axle housing of the car.

Then the thickness of this product is a little exaggerated, that is, the wall thickness of 2.5 to 8 mm, and then they want to hot melt drilling, the diameter of the tap is also very large, there are M10, M16, M20, most of these three.

Ms Wang: I see a lot of samples recently. How did they process them before they bought our equipment?

Ms Mao: Their car rear axle shell is punched a hole before, and then weld the nut on it, then this kind of processing method, the efficiency is slow, the process is more complex.

Source of this article: http://www.duomicnc.com/